So I disassemble device and bridge 7&8 pin.Ĭheck pin assignment of OBD connector and then you will seeĪnother thing is that by using OBD1->OBD2 adaptor everything works because in round connector communication lines are bridged and all is transferred to pin7 in OBD2 connector. Here, Pin 7&8 are not bridged but pin1 & 2 bridged. The solution was to disassemble device and bridge 7&8 pin.Since now it has been working flawlessly.” “In E46 2002 only with OBD2 connector BMW SCANNER didn’t want to connect with modules except engine. I try different software version, I also try two laptops (on Windows Vista 32bit, and Windows XP SP3), same problem… I have access to live data from DME module. I plug-in the diagnostic tool on the car,Īnd when I run “Car Ident” I have these two errors: “Connection error with IDE” then “Connection error with EWS.”īMW Scanner recognized only 2 modules (DME and EGS).
The software is well recognized, the drivers too. I bought a USB diagnostic tool Chinese BMW Scanner for my car, 2001 BMW 330i coupe, automatic gearbox.
